REMOTE RESET OF THE AF610 WEATHER RECEIVER “ALARM” CIRCUIT:

The circuit for the “alarm” portion of the AF610 receiver is attached. Closing contacts (7) to ground , (pin 6 is gnd) on the header HDR7 (J8) will reset the alarm circuit. A simple wired switch closure should do the job, assuming the distance is not forever. These contacts can be easily added to the DIN connector also used for the relay, i.e., Pins 1,3,5 are used for the relay, Pins 2,4 could be used for the reset.

Note: The 1650 tone decoder shown is not a standard part of the AF610. The alarm tone is 1050 Hz only.