100 KHz Switch Settings for the LM7001:
100 KHz settings for the AF210 and AF210FM Only:
To set the receiver for operation at even frequencies, use the D0 ("D", zero) switch to increase the operating frequency by 100KHz. For example, to set the frequency for 104.4MHz, follow the settings for the 104.3MHz in the Manual and then turn the switch D0 to the "On" position (D0 is "Off" for all uneven frequency settings shown in the Manual)
The D0 switch is located on the DIP switch SW1 on the printed circuit board. The SW1 positions are marked on the board and are:
SW1 position 1: Blank (No Operation)
SW1 position 2: R2
SW1 position 3: R1
SW1 position 4: D0
SW1 position 5: D1
SW1 position 6: D2
Etc.